7. Wlan Drivers for You Link-Sys Card

You have downloaded the 11 Wlan project. Go a head and read the instruction, and put it under modules. Follow the instructions when you

make config

The one key is to make sure you specify the pcmcia-source as under

/usr/src/modules/pcmcia-cs

and not choose the default it gives you.

Go ahead and

make all

and

make install

I suggest you read the documentation that comes with it, but essentially, if you have a WAP that is connected to your DSL or cable modem then you have a infrastructure set up. I found that it was best to edit the

networks.opt

under the

/etc/pcmcia

directory.

To make things easier edit the option

# Use DHCP (via /sbin/dhcpcd, /sbin/dhclient, or /sbin/pump)? [y/n]
DHCP="y"

to what I have, i.e., set it to yes.

The documentation talks about setting ESSID but when you edit the

wlan-ng.opts

you will only see

#=======INFRASTRUCTURE STATION START===================
# SSID is all we have for now
AuthType="opensystem"           # opensystem | sharedkey (requires WEP)
DesiredSSID="howardnet"

From what I can gather,DesiredSSID means ESSID and it works when the WAP and link-sys pcmcia card share the same name.

At this point, you should reboot and should have a working link-sys card that gets its address via DHCP.